CA-286 MODULAR MIC/LINE AMPLIFIER
The CA-286 preamp module is a tribute to the classic 1950’s and 60’s European two-stage amplifier made popular by Telefunken™, Langevin™, Collins™, and Gates™. The CA-286 excels in HI-FI recording applications and provides the rich and detailed midrange often associated with vintage EF86 tube based preamps.
The CA-286 PS6 preamp module uses our own Coil Audio transformers, high quality capacitors, resistors, and NOS octal tubes and is powered by our PS6 Rack Tray and Power Supply.
The (INPUT) pad section contains a phase reverse switch, and a 6 position pad network. The first four positions are various 150/250 ohm mic pads; -6db, -12db, and -19db. The final two (LN 1 & LN 2) positions allow line-level signals to run through the amplifier providing tone-shaping capabilities while mixing from your DAW, Tape Machine, or other Line Level Devices – including other Preamps.
The (NF) control varies the amount of Negative Feedback present in the circuit. Counter-clockwise brightens and moves the sound forward while raising harmonics and sensitivity. Turning it clockwise increases negative feedback, producing a darker tone with a smooth, dampened harmonic structure.
The (HI) switch transitions from the natural openness of the tubes, to a gentle filtering of upper frequencies. The (LOW) switch reacts with the NF, boosting or cutting low frequency while moving the low end from front to back in the sound stage.
The Output control knob is placed between the 1st and 2nd stage EF86 tubes and sets the final Output level.
Specifications
- 16 ga. Stainless Steel Module with Integrated XLR I/O
- Coil Audio CT-110HN high nickel input and CT-41 output transformers
installed. - 12-Step Switched Negative feedback tone control with LOW/HIGH filters.
- Two-stage Dual EF86 vacuum tube single ended parafeed circuit.
- 42db-54db of available gain.
- 150 Ohm and 2k Mic input, 20k Line input, 600 Ohm output.
- 4 Position PAD for both Mic and Line Input.
- True 180-degree Phase Switch
- Up to 6 PS6 MK2 Series Modules mount into 7U PS6 Rack Tray.
- Hand built and tested in the USA.
- NOTE: **PS6 MK2 RACK TRAY AND PSU REQUIRED FOR OPERATION**
